with longitudinal compensation

GN 808.2 Universal joint shafts with friction bearing

Universal joint shafts with friction bearing GN 808.2 thumbnail

Universal joint shafts with friction bearing GN 808.2 sketch

Bore code

B	without keyway
K	with keyway
V	with square

Show filter

d₁	d₂H7 Bore		sH11 Square V	l₁ - l₂				d₃	l₃ Guide length	l₅	t min.

22	K 10	B 10*	V 10*	140-30	160-40	180-60	-	22	30	48	12
22●	K 12	B 12*	-	140-30	160-40	180-60	-	22	30	62	18
25	K 12	B 12*	V 12*	160-30	180-45	200-70	250-105	26	40	56	13
25●	K 16	B 16*	-	160-30	180-45	200-70	250-105	26	40	74	21
28	K 14	B 14*	V 14*	170-30	200-60	220-80	280-140	29	40	60	13
32	K 14	B 16*	V 16*	190-30	240-80	275-115	380-210	32	40	68	16
32●	K 20	B 20*	-	190-30	240-80	275-115	380-210	32	40	86	24
36	K 18	B 18*	V 18*	230-50	270-100	290-110	400-220	37	40	74	17
42	K 20	B 20*	V 20*	250-50	320-120	420-220	-	42	45	82	18
42●	K 25	B 25*	-	250-50	320-120	420-220	-	42	45	108	31
45	K 22	B 22●	V 22*	270-50	330-100	470-240	-	47	50	95	22
50	K 25	B 25*	V 25*	295-50	350-100	420-170	-	52	50	108	26
50●	K 30	B 30	-	295-50	350-100	420-170	-	52	50	132	38
58	K 30	B 30*	V 30*	330-50	400-110	-	-	58	60	122	29

Filter combination produces no result.

* not availble from stock, requires a minimum order quantity

Specification

Steel blank

Joint bearing areas / pins / bearing sleeves
case hardened

Keyway P9 DIN 6885

Cross hole GN 110

ISO-Fundamental tolerances

RoHS compliant

On request

different lengths l₁ - l₂

with other or unequal bores

Information

Universal joint shafts with friction bearing GN 808.2 do not only bridge the misaligenment of two shafts, but at the same time they offer a length compensation. The power transmission is achiev-bed by two universal joints DIN 808 (type EG) a splined shaft and a sliding sleeve.

It is important to check the accuracy when connec-ting the splined shaft to the sliding sleeve.
The markings -> <- have to be opposite to each other. Any kind of misconnection leads to an inhomogeneous output and to a quick abrasion.